Dowsil SC 102 is a white, one-part, non-curing, non-flowing thermally conductive compound that provides reliable heat dissipation for electronic assemblies without needing oven curing or mixing. It offers low bleed, high stability, and easy rework for cost-effective thermal management.

• Product Type: Thermally Conductive Compound / Thermal Grease

• System: One-part

• Cure Type: Non-curing

• Color: White

• Viscosity: 29,000 cP / 29 Pa·s

• Specific Gravity (uncured): 2.4

• Bleed: 0.14%

• Non-Volatile Content (NVC): 99.7%

• Thermal Conductivity: 0.9 W/m·K (0.52 BTU/hr·ft·°F)

• Thermal Resistance (at 40 psi): 0.62 °C·cm²/W

• Dielectric Strength: 2 kV/mm (50 volts/mil)

• Dissipation Factor (50 Hz): 0.02

• Dielectric Constant (50 Hz): 4.0

• Volume Resistivity: 2×10¹⁶ Ohm·cm

• One-part, non-curing formula – no mixing, no heating, no curing required; ready to use.

• Non-flowing consistency – stays in place, no migration or mess during assembly and operation.

• Low bleed & high stability – minimal oil separation, long service life, no dry-out.

• Moderate thermal conductivity – efficient heat transfer for standard electronics cooling.

• Easy to apply & rework – supports stencil/screen printing and simple assembly repair.

• PCB assembly thermal management – heat transfer between components and heat sinks.

• Computer & MPU cooling – thermal interface for CPUs, motherboards, and computing modules.

• Power supply device cooling – reliable heat dissipation for adapters and industrial power units.

• Automotive electronics cooling – thermal compound for vehicle control modules and sensors.

• General consumer electronics – cost-effective thermal solution for household devices.