Molykote G-807 silicone Compound is a soft, white, non-melting silicone grease formulated with PTFE solid lubricants. It is designed for low-friction lubrication of plastic-to-metal, metal-to-rubber, and elastomer interfaces. The compound provides stable lubrication and corrosion protection across moderate temperature ranges, while maintaining compatibility with common plastics and sealing materials used in automotive and electromechanical assemblies.

• Non-Melting Structure - Molykote G-807 exhibits non-melting characteristics and maintains grease consistency without a defined dropping point. The compound operates within a service temperature range of -40 °C to 150 °C, retaining structure and lubrication performance without softening or oil separation.

  
  

• Low Friction Control - The PTFE-modified formulation provides stable low-friction performance under light to moderate load conditions. The compound reduces stick-slip behavior in sliding plastic and rubber interfaces, supporting smooth movement in assemblies requiring controlled actuation.

  
  

• Material Compatibility - Molykote G-807 is compatible with a wide range of plastics and elastomers, including common sealing materials. The silicone base chemistry minimizes swelling, embrittlement, or degradation of rubber and polymer components during prolonged contact.

  
  

• Corrosion Protection - The grease provides surface protection against moisture-induced corrosion on metal components. Its silicone formulation forms a protective film that resists oxidation and supports long-term reliability in damp operating environments.

  
  

• Water Resistance - Molykote G-807 demonstrates resistance to water exposure and washout, maintaining lubrication presence in humid or splash-prone environments. This property supports stable performance where moisture contact is unavoidable.

• Brake Caliper Pins - Molykote G-807 is applied to brake caliper guide pins during assembly or maintenance. The grease is spread evenly along the pin surface to support smooth sliding motion and reduce sticking under temperature variation and exposure to road moisture.

  
  

• Automotive Ball Joints - The compound is introduced into ball joint housings to provide low-friction movement between metal and polymer contact surfaces. Its compatibility with elastomers supports seal integrity during repeated articulation cycles.

  
  

• Control Cables - Molykote G-807 is applied inside control cable housings to reduce friction between cable wires and liners. The grease supports consistent movement across the service temperature range without grease hardening or migration.

  
  

• Plastic and Rubber Interfaces - The compound is used on plastic-to-plastic and rubber-to-metal interfaces in electromechanical assemblies. It is applied as a thin layer during assembly to ensure smooth engagement and prevent wear.

  
  

• Valves and O-Rings - Molykote G-807 is applied to valve stems, seals, and O-rings prior to installation. The grease supports lubrication during assembly and operation while maintaining compatibility with sealing materials exposed to moderate heat and moisture.